Lutron Sivoia QS Roller Shades Installation Guide: Quick Programming Reference Card (3671692, rev A)

Installation walk-through for 3671692

Lutron document 3671692 gives six steps, in the document's order.

The clearance, the check and the warning under a step are the document's own.

1. Check the link from a drive

   Hold Close on a drive for 5 seconds, then tap CCW to enter link diagnostics mode. Every shade and drapery on the link wiggles.

   Hold Close to leave the mode.

   Check: A shade or drapery that does not wiggle has its wiring checked.

2. Or check the link from the smart panel

   At the Sivoia QS smart panel, tap Open and then hold it for 5 seconds, and do that twice. All shades and draperies wiggle.

   A 5-second hold on Open exits.

   Check: Every shade and drapery wiggled.

3. Assign shades and draperies to a keypad

   Hold Open and Close together for 5 seconds: assigned units close and unassigned ones open. Tap Open to jog forward or Close to jog backward.

   Tap Lower to assign the selected unit or Raise to unassign it. Hold Open and Close for 5 seconds to exit; the units go back to where they started.

4. Set limits from a keypad

   Hold Open and Raise together for 5 seconds, then jog through the assigned units with Open and Close. Move the selected unit with Raise and Lower.

   Save its open limit with a hold on Open, or its close limit with a hold on Close. Exit with Open and Raise held together for 5 seconds.

5. Store a preset

   With the shades and draperies in position, hold the chosen Preset button for 5 seconds to save their positions.

6. Adjust single units within a preset

   Hold Open and Close together for 5 seconds, then tap the preset so the units move to its stored positions. Jog to an assigned unit with Open or Close, set it with Raise and Lower, and repeat for any others.

   Hold the preset for 5 seconds to store, then Open and Close for 5 seconds to exit.